Okey dokey, lets get started.
First of all, the most basic thing to do, how to remove the pegs in your clip. Really, this is all you need to do to your magstirke buy anyway, Grab your clip and get a strong knife and put it in the holes were the pegs are and then twist and break the pegs out. But make sure you use a strong knife not an exact-o knife or Stanly knife otherwise it might break. You could also one of the blades for a pair of scissors to do this.
And it should look like this
now grab some E-Tape and wrap 2-3 wraps around the clip. What this does is stops the clip from falling out the gun while your running. (Note the PS3 in the backgorund :D)
Now to take your gun apart, take all the screws out (dur) and then you see the orange part where the pump is? thats glued on so to take it odd, (this is how it did it) just bend the shell up and it should snap off.
Ok, so now you got your magstrike open, here's the internals if you need them
Where gonna start by taking out the trigger lock. Take the trigger and the orange part above it out, and then take the peiced under that orange part out and then screw the orange part back in.
Now take your trigger, and you want to gut a piece of 3mm polycarbonate, or PVC sheet and glue it on the place shown. I used super glue as its stronger that hot-glue.
What this does is make a faster air release (I think) with a smaller trigger stroke.
Now were gonna make a Sling point so you can carry this around easily. For this you need an eye bolt and a drill. Grab the Black piece and drill a hole through it and then bolt your eye-bolt through it.
And there you have it, I did some other mods but they didn't do much so i'll just leave them out.
- Brad
First of all, the most basic thing to do, how to remove the pegs in your clip. Really, this is all you need to do to your magstirke buy anyway, Grab your clip and get a strong knife and put it in the holes were the pegs are and then twist and break the pegs out. But make sure you use a strong knife not an exact-o knife or Stanly knife otherwise it might break. You could also one of the blades for a pair of scissors to do this.
And it should look like this
now grab some E-Tape and wrap 2-3 wraps around the clip. What this does is stops the clip from falling out the gun while your running. (Note the PS3 in the backgorund :D)
Now to take your gun apart, take all the screws out (dur) and then you see the orange part where the pump is? thats glued on so to take it odd, (this is how it did it) just bend the shell up and it should snap off.
Ok, so now you got your magstrike open, here's the internals if you need them
Where gonna start by taking out the trigger lock. Take the trigger and the orange part above it out, and then take the peiced under that orange part out and then screw the orange part back in.
Now take your trigger, and you want to gut a piece of 3mm polycarbonate, or PVC sheet and glue it on the place shown. I used super glue as its stronger that hot-glue.
What this does is make a faster air release (I think) with a smaller trigger stroke.
Now were gonna make a Sling point so you can carry this around easily. For this you need an eye bolt and a drill. Grab the Black piece and drill a hole through it and then bolt your eye-bolt through it.
And there you have it, I did some other mods but they didn't do much so i'll just leave them out.
- Brad