The Spy Gear Signal Launcher (or SGSL) is another blaster that uses the big blasts internals. This one is the most expensive of the lot and the smallest. its around the size of a Dart Tag blaster. Its a riot to play with stock. the signal missiles go about 45 feet with some speed. and whistle along. oversized ammo kicks ass.
Modding this thing to fire stefans is simple as pie. you don't even have to open it.
Here it is in all its stock glory. if your wondering, the trigger is the button on the back.
cut the barrel, leaving about 19mm still on there.
Now here was my sticking point. I thought this was an Air restrictor, so i tried to remove it and fucked shit up. I cracked the barrel (as you can notice in image 2) and jammed the firing pin open when i got at it with a screw driver. To make your life easy, just leave it there.
If you do want to remove try a dremel, instead or barging in there with wire cutters and a screwdriver. Just remember to dremel carefully or you will cut through the valve behind it.
go ahead and stick a 15mm coupler over the stub. the way i stuck it on was to wrap the stub with electrical tape so the coupler had a nice fit over it, then hot glued it in place.
I used my big blasts 12 inch Hep20 leap speedloader on it and it shot my dart out just as good as my big blast can, maybe even faster. Unfortunatly the Spy Gear Signal Launcher is not as easy to aim as a big blast with its small size and odd trigger, but its still awesome.
Modding this thing to fire stefans is simple as pie. you don't even have to open it.
Here it is in all its stock glory. if your wondering, the trigger is the button on the back.
cut the barrel, leaving about 19mm still on there.
Now here was my sticking point. I thought this was an Air restrictor, so i tried to remove it and fucked shit up. I cracked the barrel (as you can notice in image 2) and jammed the firing pin open when i got at it with a screw driver. To make your life easy, just leave it there.
If you do want to remove try a dremel, instead or barging in there with wire cutters and a screwdriver. Just remember to dremel carefully or you will cut through the valve behind it.
go ahead and stick a 15mm coupler over the stub. the way i stuck it on was to wrap the stub with electrical tape so the coupler had a nice fit over it, then hot glued it in place.
I used my big blasts 12 inch Hep20 leap speedloader on it and it shot my dart out just as good as my big blast can, maybe even faster. Unfortunatly the Spy Gear Signal Launcher is not as easy to aim as a big blast with its small size and odd trigger, but its still awesome.
Last edited by Roger Explosion on Wed Nov 25, 2009 9:49 am; edited 1 time in total